Reference Manual

. . . . .
www.digiembedded.com 134
Note: The higher VLIO current of 400 MHz variant due to speed grade specific
S3C2443 PLL voltage requirements.
 U-Boot
– U-Boot idle; waiting for serial input
– 100 Mbit Ethernet connection idle
– All peripherals provided with clock signals, but not initialized
 Windows Embedded CE
– Windows Embedded CE idle
– 100 Mbit Ethernet connection idle
– All peripherals except camera and sound provided with clock signals and
initialized
 Ethernet Reset
– Windows Embedded CE idle
– 100 Mbit Ethernet connection idle
– All peripherals except camera and sound provided with clock signals and
initialized
– Ethernet controller held in reset (GPIO GPA13/ETH_RST# low)
 Suspend (CPU in SLEEP mode)
– Windows Embedded CE
– Ethernet deactivated
– All peripheral and CPU clocks stopped, all SoC IP blocks deactivated
ConnectCore
“Wi-9M 2443”
533MHz 400MHz
Module State VLIO +3.3V Typical
Power
VLIO +3.3V Typical
Power
U-Boot 197mA 267mA 1532mW 237mA 232mA 1548mW
Windows CE 220mA 284mA 1664mW 222mA 238mA 1518mW
Ethernet Reset 224mA 190mA 1367mW 222mA 142mA 1202mW
Module State VLIO +3.3V Typical
Power
VLIO +3.3V Typical
Power