Reference Manual

146 ConnectCore 9M 2443 & Wi-9M 2443 Hardware Reference
Appendix B
RF Exposure
RF Exposure considerations require that a 20 cm separation distance between users
and the installed antenna location shall be maintained at all times when the module
is energized. OEM installers must consider suitable module and antenna installation
locations in order to assure this in 20cm separation, and end users be also be
advised ot the requirement.
Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly approved by Digi may void
the user’s authority to operate this equipment.
Industry Canada
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depassant les
limites applicables aux appareils numeriques de la class B prescrites dans le
Reglement sur le brouillage radioelectrique edicte par le ministere des
Communications du Canada.
The maximum antenna gain permitted in the bands 5250-5350 MHz and 5470-5725
MHz to comply with the e.i.r.p limit is, according to RSS-210 section A9.2(2)
 250mW conducted power
 1.0W max EIRP
This limit is met with the highest gain antenna listed,antennafactor
ANT-DB1-RAF-RPS.
The maximum antenna gain permitted in the band 5725-5825 MHz to comply with
the e.i.r.p limit specified for non point-to-point operation is,according to RSS-210
section A9.2(3):
 1W conducted power
 4.0W max EIRP
This limit is met with the highest gain antenna listed,antennafactor
ANT-DB1-RAF-RPS.