Reference Manual

69 ConnectCore 9M 2443 & Wi-9M 2443 Hardware Reference
Chapter 2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Switches and push-buttons
Reset control, S1 The reset push-button S1, resets the module. On the module, RSTOUT# and
PWRGOOD are produced for peripherals. A push-button allows manual reset by
connecting RSTIN# to ground. The reset controller is located on the module.
Power switch, S2 The development board has an ON/OFF switch S2. The power switch S2 can switch
both 9V-30V input power supply and 12V coming out of the PoE module. However, if
a power plug is connected to the DC power jack, the PoE module is disabled. User
pushbuttons, S3 and S5.
Configuration
switches, S4
Power switch, S2
Serial
port A
switch,
S7
Serial
port B
switch,
S6
Reset button, S1
User
button 1,
S3
User
button 2,
S5