User's Manual
Table Of Contents
ABOUT THE DEVELOPMENT BOARD
Switches and reset functionality
18 Digi Connect Wi-Wave 802.11 b/g Hardware Reference, Rev. B 2/2010
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Switches and reset functionality
Voltage monitor The development board provides a power supply voltage monitor and reset
generator. When the +3.3V regulated supply voltage drops below 2.93V, the reset
signal — RESET# — is asserted for a minimum of 140 msec. This signal is connected
to the Digi Connect Wi-Wave 802.11 b/g edge connector (pin 22), as well as to the
debug breakout header for monitoring.
Alternative
methods to trigger
RESET#
In addition to supply voltage monitoring, reset logic can be triggered in another
way:
Manually push SW1, a pushbutton reset switch on the development board