User's Manual
Table Of Contents
ABOUT THE DEVELOPMENT BOARD
Debug breakout header, P21
22 Digi Connect Wi-Wave 802.11 b/g Hardware Reference, Rev. B 2/2010
W_DISABLE#
signal
The active low W_DISABLE# signal is on pin 20 of the debug breakout header. GND
signals are positioned adjacent to the W_DISABLE# signal on pins 18 and 19. To
assert the W_DISABLE# signal to the module, place a jumper between either pins 18
and 20 or pins 19 and 20.
As an alternative, you can drive this pin with a low voltage TTL or CMOS driver.
When asserted, W_DISABLE# lights the DISABLE LED, DS3.