User's Manual

. . . . .
ABOUT THE DEVELOPMENT BOARD
U.FL and RP-SMA connectors
www.digiembedded.com 23
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
U.FL and RP-SMA connectors
U.FL connectors The development board has two U.FL connectors that pair with two RP-SMA
connectors. U.FL connector X5pairs with RP-SMA connector J1;U.FL connector X4
pairs with RP-SMA connector J2.
U.FL cables The development kit includes two U.FL-to-U.FL cables that can be used to connect
the module and development board. The number of cables used depends on
whether one antenna is used to transmit and receive or two antennas are used
(diversity receive).
Single antenna configuration: Connect one end of the U.FL cable to connector P1
on the development board and the other end of the cable to connector X5 on the
Digi Connect Wi-Wave 802.11 b/g module.
Dual antenna configuration: In addition to the connections outlined in the Single
antenna configuration, connect one end of the second U.FL cable to connector P2
on the development board and the other end of the cable to connector X4 on the
Digi Connect Wi-Wave 802.11 b/g module.