User Manual

 25
About the Development Board
Connectors and Blocks
The development board provides the following connectors and blocks:
 JTAG Debugger Connector (P4)
 SPI Connector (P11) and SPI Jumper Block
 Logic Signal Analyzer Header (P6)
 Main Connector (P8)
JTAG Debugger Connector (P4)
This 14-pin male vertical header labeled P4 mates with a JTAG debugger plug (for
example, a Macraigor Raven). It is used with the development kit only. See the following
figure and table for pin orientation and assignments.
GPIO Port Pin Assignments
Pin Signal Name
1GND
2GPIO-9
3GPIO-8
4GPIO-7
5GPIO-6
6GPIO-5
7GPIO-4
8GPIO-3
9GPIO-2
10 GPIO-1