User's Manual
Table Of Contents
- 1. XTend RF Module
- 2. RF Module Operation
- 3. RF Module Configuration
- Programming Examples
- Command Reference Table
- Command Descriptions
- %V (Board Voltage) Command
- AM (Auto-set MY) Command
- AP (API Enable) Command
- AT (Guard Time After) Command
- BD (Interface Data Rate) Command
- BR (RF Data Rate) Command
- BT (Guard Time Before) Command
- CC (Command Sequence Character) Command
- CD (GPO2 Configuration) Command
- CF (Number Base) Command
- CN (Exit AT Command Mode) Command
- CS (GPO1 Configuration) Command
- CT (Command Mode Timeout) Command
- DB (Received Signal Strength) Command
- DT (Destination Address) Command
- E0 (Echo Off) Command
- E1 (Echo On) Command
- ER (Receive Error Count) Command
- FH (Force Wake-up Initializer) Command
- FL (Software Flow Control) Command
- FS (Forced Synch Time) Command
- FT (Flow Control Threshold) Command
- GD (Receive Good Count) Command
- HP (Hopping Channel) Command
- HT (Time before Wake-up Initializer) Command
- HV (Hardware Version) Command
- ID (Modem VID) Command
- KY (AES Encryption Key) Command
- LH (Wake-up Initializer Timer) Command
- MD (RF Mode) Command
- MK (Address Mask) Command
- MT (Multi-transmit) Command
- MY (Source Address) Command
- NB (Parity) Command
- PB (Polling Begin Address) Command
- PD (Minimum Polling Delay) Command
- PE (Polling End Address) Command
- PK (Maximum RF Packet Size) Command
- PL (TX Power Level) Command
- PW (Pin Wake-up) Command
- RB (Packetization Threshold) Command
- RC (Ambient Power - Single Channel) Command
- RE (Restore Defaults) Command
- RM (Ambient Power - All Channels) Command
- RN (Delay Slots) Command
- RO (Packetization Timeout) Command
- RP (RSSI PWM Timer) Command
- RR (Retries) Command
- RT (GPI1 Configuration) Command
- SB (Stop Bits) Command
- SH (Serial Number High) Command
- SL (Serial Number Low) Command
- SM (Sleep Mode) Command
- ST (Time before Sleep) Command
- TP (Board Temperature) Command
- TR (Transmit Error Count) Command
- TT (Streaming Limit) Command
- TX (Transmit Only) Command
- VL (Firmware Version - Verbose)
- VR (Firmware Version - Short) Command
- WA (Active Warning Numbers) Command
- WN (Warning Data) Command
- WR (Write) Command
- WS (Sticky Warning Numbers) Command
- API Operation
- 4. RF Communication Modes
- Appendix A: Agency Certifications
- Appendix B: Development Guide
- Appendix C: Additional Information
XTend™RFModule‐ProductManual
©2013DigiInternatonal,Inc. 57
Antenna Options (1-watt transmit power output or lower)
The antennas in the tables below have been approved for use with this module. Digi does not carry all of these antenna vari-
ants. Contact Digi Sales for available antennas.
Half‐waveantennas(approvedwhenoperatingat1‐wattpoweroutputorlower)
Part Number Type Connector Gain Application
A09-HSM-7 Straight half-wave RPSMA 3.0 dBi Fixed / Mobile
A09-HASM-675 Articulated half-wave RPSMA 2.1 dBi Fixed / Mobile
A09-HABMM-P6I Articulated half-wave w/ 6" pigtail MMCX 2.1 dBi Fixed / Mobile
A09-HABMM-6-P6I Articulated half-wave w/ 6" pigtail MMCX 2.1 dBi Fixed / Mobile
A09-HBMM-P6I Straight half-wave w/ 6" pigtail MMCX 2.1 dBi Fixed / Mobile
A09-HRSM Right angle half-wave RPSMA 2.1 dBi Fixed
A09-HASM-7 Articulated half-wave RPSMA 2.1 dBi Fixed
A09-HG Glass mounted half-wave RPSMA 2.1 dBi Fixed
A09-HATM Articulated half-wave RPTNC 2.1 dBi Fixed
A09-H Half-wave dipole RPSMA 2.1 dBi Fixed
Yagiantennas(approvedwhenoperatingat1‐wattpoweroutputorlower)
Part Number Type Connector Gain Required Antenna Cable Loss Application
A09-Y6 2 Element Yagi RPN 6.1 dBi 1.7 dB Fixed / Mobile
A09-Y7 3 Element Yagi RPN 7.1 dBi 2.7 dB Fixed / Mobile
A09-Y8 4 Element Yagi RPN 8.1 dBi 3.7 dB Fixed / Mobile
A09-Y9 4 Element Yagi RPN 9.1 dBi 4.7 dB Fixed/ Mobile
A09-Y10 5 Element Yagi RPN 10.1 dBi 5.7 dB Fixed / Mobile
A09-Y11 6 Element Yagi RPN 11.1 dBi 6.7 dB Fixed / Mobile
A09-Y12 7 Element Yagi RPN 12.1 dBi 7.7 dB Fixed / Mobile
A09-Y13 9 Element Yagi RPN 13.1 dBi 8.7 dB Fixed / Mobile
A09-Y14 10 Element Yagi RPN 14.1 dBi 9.7 dB Fixed / Mobile
A09-Y14 12 Element Yagi RPN 14.1 dBi 9.7 dB Fixed / Mobile
A09-Y15 13 Element Yagi RPN 15.1 dBi 10.7 dB Fixed / Mobile
A09-Y15 15 Element Yagi RPN 15.1 dBi 10.7 dB Fixed / Mobile
A09-Y6TM 2 Element Yagi RPTNC 6.1 dBi 1.7 dB Fixed / Mobile
A09-Y7TM 3 Element Yagi RPTNC 7.1 dBi 2.7 dB Fixed / Mobile
A09-Y8TM 4 Element Yagi RPTNC 8.1 dBi 3.7 dB Fixed / Mobile
A09-Y9TM 4 Element Yagi RPTNC 9.1 dBi 4.7 dB Fixed / Mobile
A09-Y10TM 5 Element Yagi RPTNC 10.1 dBi 5.7 dB Fixed / Mobile
A09-Y11TM 6 Element Yagi RPTNC 11.1 dBi 6.7 dB Fixed / Mobile
A09-Y12TM 7 Element Yagi RPTNC 12.1 dBi 7.7 dB Fixed / Mobile
A09-Y13TM 9 Element Yagi RPTNC 13.1 dBi 8.7 dB Fixed / Mobile
A09-Y14TM 10 Element Yagi RPTNC 14.1 dBi 9.7 dB Fixed / Mobile
A09-Y14TM 12 Element Yagi RPTNC 14.1 dBi 9.7 dB Fixed / Mobile
A09-Y15TM 13 Element Yagi RPTNC 15.1 dBi 10.7 dB Fixed / Mobile
A09-Y15TM 15 Element Yagi RPTNC 15.1 dBi 10.7 dB Fixed / Mobile
Omni‐directionalbasestationantennas(approvedwhenoperatingat1‐wattpoweroutputorlower)
Part Number Type Connector Gain Required Antenna Cable Loss Application
A09-F0 Fiberglass Base Station RPN 0 dBi - Fixed
A09-F1 Fiberglass Base Station RPN 1.0 dBi - Fixed
A09-F2 Fiberglass Base Station RPN 2.1 dBi - Fixed
A09-F3 Fiberglass Base Station RPN 3.1 dBi - Fixed
A09-F4 Fiberglass Base Station RPN 4.1 dBi - Fixed
A09-F5 Fiberglass Base Station RPN 5.1 dBi - Fixed
A09-F6 Fiberglass Base Station RPN 6.1 dBi 0.1 dB* Fixed
A09-F7 Fiberglass Base Station RPN 7.1 dBi 1.1 dB* Fixed
A09-F8 Fiberglass Base Station RPN 8.1 dBi 2.1 dB* Fixed
A09-W7 Wire Base Station RPN 7.1 dBi 1.1 dB* Fixed
A09-F0 Fiberglass Base Station RPSMA 0 dBi - Fixed
A09-F1 Fiberglass Base Station RPSMA 1.0 dBi - Fixed
A09-F2 Fiberglass Base Station RPSMA 2.1 dBi - Fixed
A09-F3 Fiberglass Base Station RPSMA 3.1 dBi - Fixed
A09-F4 Fiberglass Base Station RPSMA 4.1 dBi - Fixed
A09-F5 Fiberglass Base Station RPSMA 5.1 dBi - Fixed
A09-F6 Fiberglass Base Station RPSMA 6.1 dBi 0.1 dB* Fixed