User's Manual
Table Of Contents
- 1. XTend RF Module
- 2. RF Module Operation
- 3. RF Module Configuration
- Programming Examples
- Command Reference Table
- Command Descriptions
- %V (Board Voltage) Command
- AM (Auto-set MY) Command
- AP (API Enable) Command
- AT (Guard Time After) Command
- BD (Interface Data Rate) Command
- BR (RF Data Rate) Command
- BT (Guard Time Before) Command
- CC (Command Sequence Character) Command
- CD (GPO2 Configuration) Command
- CF (Number Base) Command
- CN (Exit AT Command Mode) Command
- CS (GPO1 Configuration) Command
- CT (Command Mode Timeout) Command
- DB (Received Signal Strength) Command
- DT (Destination Address) Command
- E0 (Echo Off) Command
- E1 (Echo On) Command
- ER (Receive Error Count) Command
- FH (Force Wake-up Initializer) Command
- FL (Software Flow Control) Command
- FS (Forced Synch Time) Command
- FT (Flow Control Threshold) Command
- GD (Receive Good Count) Command
- HP (Hopping Channel) Command
- HT (Time before Wake-up Initializer) Command
- HV (Hardware Version) Command
- ID (Modem VID) Command
- KY (AES Encryption Key) Command
- LH (Wake-up Initializer Timer) Command
- MD (RF Mode) Command
- MK (Address Mask) Command
- MT (Multi-transmit) Command
- MY (Source Address) Command
- NB (Parity) Command
- PB (Polling Begin Address) Command
- PD (Minimum Polling Delay) Command
- PE (Polling End Address) Command
- PK (Maximum RF Packet Size) Command
- PL (TX Power Level) Command
- PW (Pin Wake-up) Command
- RB (Packetization Threshold) Command
- RC (Ambient Power - Single Channel) Command
- RE (Restore Defaults) Command
- RM (Ambient Power - All Channels) Command
- RN (Delay Slots) Command
- RO (Packetization Timeout) Command
- RP (RSSI PWM Timer) Command
- RR (Retries) Command
- RT (GPI1 Configuration) Command
- SB (Stop Bits) Command
- SH (Serial Number High) Command
- SL (Serial Number Low) Command
- SM (Sleep Mode) Command
- ST (Time before Sleep) Command
- TP (Board Temperature) Command
- TR (Transmit Error Count) Command
- TT (Streaming Limit) Command
- TX (Transmit Only) Command
- VL (Firmware Version - Verbose)
- VR (Firmware Version - Short) Command
- WA (Active Warning Numbers) Command
- WN (Warning Data) Command
- WR (Write) Command
- WS (Sticky Warning Numbers) Command
- API Operation
- 4. RF Communication Modes
- Appendix A: Agency Certifications
- Appendix B: Development Guide
- Appendix C: Additional Information
XTend™RFModule‐ProductManual
©2013DigiInternatonal,Inc. 58
*FCCregulationsstipulatea36dBmEIRPpowerrequirement.Usersimplementingantennagaingreaterthan6.0dBmustcompensateforthe
addedgainwithcableloss.Whenoperatingat1Wpoweroutput,thesum(indB)ofcablelossandantennagainshallnotexceed6.0dB.
Disc patch antennas (approved when operating at 1-watt power level power output or lower)
*
FCCregulationsstipulatea36dBmEIRPpowerrequirement.Usersimplementingantennagaingreaterthan6.0dBmustcompensateforthe
addedgainwithcableloss.Whenoperatingat1Wpoweroutput,thesum(indB)ofcablelossandantennagainshallnotexceed6.0dB.
Antenna Options (100 mW transmit power output or lower)
A09-F7 Fiberglass Base Station RPSMA 7.1 dBi 1.1 dB* Fixed
A09-F8 Fiberglass Base Station RPSMA 8.1 dBi 2.1 dB* Fixed
A09-W7SM Wire Base Station RPSMA 7.1 dBi 1.1 dB* Fixed
A09-F0TM Fiberglass Base Station RPTNC 0 dBi - Fixed
A09-F1TM Fiberglass Base Station RPTNC 1.0 dBi - Fixed
A09-F2TM Fiberglass Base Station RPTNC 2.1 dBi - Fixed
A09-F3TM Fiberglass Base Station RPTNC 3.1 dBi - Fixed
A09-F4TM Fiberglass Base Station RPTNC 4.1 dBi - Fixed
A09-F5TM Fiberglass Base Station RPTNC 5.1 dBi - Fixed
A09-F6TM Fiberglass Base Station RPTNC 6.1 dBi 0.1 dB* Fixed
A09-F7TM Fiberglass Base Station RPTNC 7.1 dBi 1.1 dB* Fixed
A09-F8TM Fiberglass Base Station RPTNC 8.1 dBi 2.1 dB* Fixed
A09-W7TM Wire Base Station RPTNC 7.1 dBi 1.1 dB* Fixed
Part Number Type Connector Gain Required Antenna Cable Loss Application
51-43-8227 Disc patch MMCX 0 dBi 0 dB Fixed/ Mobile
Mag Mount antennas (approved when operating at 1?watt power output or lower)
Part Number Type Connector Gain Required Antenna Cable Loss Application
A09-M0SM Mag Mount RPSMA 0 dBi - Fixed
A09-M2SM Mag Mount RPSMA 2.1 dBi - Fixed
A09-M3SM Mag Mount RPSMA 3.1 dBi - Fixed
A09-M5SM Mag Mount RPSMA 5.1 dBi - Fixed
A09-M7SM Mag Mount RPSMA 7.1 dBi 1.1 dB* Fixed
A09-M8SM Mag Mount RPSMA 8.1 dBi 2.1 dB* Fixed
A09-M0TM Mag Mount RPTNC 0 dBi - Fixed
A09-M2TM Mag Mount RPTNC 2.1 dBi - Fixed
A09-M3TM Mag Mount RPTNC 3.1 dBi - Fixed
A09-M5TM Mag Mount RPTNC 5.1 dBi - Fixed
A09-M7TM Mag Mount RPTNC 7.1 dBi 1.1 dB* Fixed
A09-M8TM Mag Mount RPTNC 8.1 dBi 2.1 dB* Fixed
Multi‐pathantennas(approvedwhenoperatingat1‐wattpoweroutputorlower)
Part Number Type Connector Gain Application
A09-DPSM-P12F omni directional permanent mount w/ 12ft pigtail RPSMA 3.0 dBi Fixed
A09-D3NF-P12F omni directional magnetic mount w/ 12ft pigtail RPN 3.0 dBi Fixed
A09-D3SM-P12F omni directional w/ 12ft pigtail RPSMA 3.0 dBi Fixed
A09-D3PNF omni directional permanent mount RPN 3.0 dBi Fixed
A09-D3TM-P12F omni directional w/ 12ft pigtail RPTNC 3.0 dBi Fixed
A09-D3PTM omni directional permanent mount RPTNC 3.0 dBi Fixed
A92-D4PNF 900 MHz / 2.4GHz permanent mount RPN 2.1 dBi Fixed
A92-D4P 900 MHz / 2.4GHz permanent mount RPSMA 2.1 dBi Fixed
A92-D4PTM 900 MHz / 2.4GHz permanent mount RPTNC 2.1 dBi Fixed
Half‐waveantennas(approvedwhenoperatingat100mWpoweroutputorlower)
Part Number Type Connector Gain Application
A09-QW Quarter-wave wire Permanent 1.9 dBi Fixed / Mobile
A09-QRAMM 3 " Quarter-wave wire MMCX 2.1 dBi Fixed / Mobile
A09-QSM-3 Quarter-wave straight RPSMA 1.9 dBi Fixed / Mobile
A09-QSM-3H Heavy duty quarter-wave straight RPSMA 1.9 dBi Fixed / Mobile
A09-QBMM-P6I Quarter-wave w/ 6" pigtail MMCX 1.9 dBi Fixed / Mobile
A09-QHRN Miniature Helical Right Angle solder Permanent -1 dBi Fixed / Mobile
A09-QHSN Miniature Helical Right Angle solder Permanent -1 dBi Fixed / Mobile
A09-QHSM-2 2" Straight RPSMA 1.9 dBi Fixed / Mobile
A09-QHRSM-2 2" Right angle RPSMA 1.9 dBi Fixed / Mobile
Omni‐directionalbasestationantennas(approvedwhenoperatingat1‐wattpoweroutputorlower)
Part Number Type Connector Gain Required Antenna Cable Loss Application