SERVICE MANUAL NF-02 SUBGIGA RFID READER NF-02 Tentative Edition COPYRIGHT © 2005 TERAOKA WEIGH-SYSTEM PTE LTD
Table of Content i) Notice ................................................................................................................................................. 1 ii) Safety Information .............................................................................................................................. 2 iii) Safety Regulations ............................................................................................................................. 2 1. General ................
i) Notice DIGI® The material contained in this document is proprietary and for information only and is subject to change without notice. Teraoka Weigh-System assumes no responsibility for any errors or damages arising from misinterpretation of any procedure. Screen displays, operating procedures and supporting features might vary with different software version releases. This document shall not be reproduced whether in part or whole without the written consent from Teraoka Weigh-System Pte Ltd.
ii) Safety Information The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with these requirements. • Repair and servicing of product, shall only be carried out by trained and qualified personnel. Disclaimer: Specifications are subject to change without notice. All dimensions shown are approximate.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
NF-02 Service Manual 1. General 1.1 Model Specification Model : NF-02 Dimension (in mm) : 180.0 (L) X 39.0 (W) X 39.
NF-02 Service Manual 2.1 Dimension 2.
NF-02 Service Manual 2.
NF-02 Service Manual 3. NF-02 Setup Diagram 3.1 Setup Diagram The NF-02 RFID reader will used as accessories within teraoka machine. NF-02 to be fixed at designated location of Teraoka machine, eg weighing and POS machine. The NF-02 will detect UHF passive tags which contain user id for logon purpose. The typical detection range between tag and reader is 50cm or more. Upon detection, the NF-02 would enter idle mode.
NF-02 Service Manual 4. Revision Records Serial No.
