Owner's Manual

10
4. Guitar In
This ¼″ unbalanced TS Guitar In connects directly to the guitar
for use by musIQ
®
harmony generation.
Note: It is important for the Vocalist Live 3 to be the first device
in the guitar signal chain to ensure proper analysis of the guitar
signal for harmony generation.
5. Guitar Thru
The guitar signal received on the Guitar In is passed through the
¼″ unbalanced TS Guitar Thru to connect to guitar effects and/or
an amplifier.
6. Stereo Mono Select
This switch selects whether the Outputs are stereo or mono.
When Mono is selected, both Outputs have the same signal and
stereo imaging is lost.
7. Left Out
These balanced XLR outputs provide a stereo mix of Lead Vocal
and Harmony Voices. The signal level coming from of the outs
could be described as a “hot” mic-level signal. It should be com-
patible with both the mic input of a mixer (with the input trim
turned down somewhat) and with a line input on the mixer (with
the level set higher).
8. Right Out
Balanced XLR output of the right channel.
9. Ground Lift Switch
This switch lifts Pin 1 of the XLR Outputs from all ground refer-
ences and may help break troublesome ground loops that cause
hum between a Mixer and a guitar amplifier.
10. Power Input
Connect only the supplied PS-0913AC adapter here to power
the Vocalist Live 3.