Owner's Manual

13
To set the Guitar Sensitivity Press the Setup button to enter Setup
Mode. Follow the instructions on adjusting Setup parameters later in
this manual.
Tune the Guitar
It is important for your guitar to be properly tuned
in order for the musIQ
®
technology to generate
the best sounding harmonies. Alternate tunings
(for example, DADGAD or tuning down) are fine,
as long as the built-in tuner shows each string as in
tune. If you are using an external tuner, make sure
that the tuner’s reference is set to 440 Hz.
To use the built-in tuner, press
and hold the Effect footswitch
to start the Guitar Tuner. The
Effect LED will flash while the
Tuner mode is active. Note that
for the Tuner to work properly
it needs to receive adequate guitar signal strength, which is indicated
by the Guitar Signal Strength indicator.
As each string is individually played, the closest note to that played will
appear on the Display and the Tuner LEDs will show the deviation in
pitch from the target note. If the string is in tune with the target note,
the green center Tuner LED will be lit. LEDs to the left will light if the
string is flat and bars to the right if the string is sharp.
When all strings are in tune, press the Effects footswitch to exit the
Guitar Tuner.
Adjust the Vocal Level
Using the Input Gain knob on the rear of the unit, adjust the level so
the Vocal level LED lights green when you sing normally and lights
amber when you sing loudly. Avoid having the vocal level LED light red
if possible.
Adjust the Effects and Choose the Harmonies
You are now ready to adjust the effects and choose harmonies as
described in the following sections.
'UITAR
6OCAL
(ARMONY0ATCH
/CTAVE
- & - &
(IGHER
(IGH
$OUBLE
,OW
,OWER
"ASS
A