DECLARATION OF CONFORMITY Manufacturer’s Name: Manufacturer’s Address: DigiTech 8760 S. Sandy Parkway Sandy, Utah 84070, USA Warning For your protection, please read the following: declares that the product: Product name: Multi Chorus Product option: all (requires Class II power adapter that conforms to the requirements of EN60065, EN60742, or equivalent.
WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty. 2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service. 3.
DigiTech has long been known as a leader in the guitar signal processing industry. The Multi Chorus is a culmination of this expertise, bringing you a breakthrough in chorus effect technology. Thanks to our proprietary AudioDNA™ processor, the Multi Chorus is the only pedal that provides up to16 independent voices of interactive chorusing. The result is a lush wash of modulation that rivals any of the finest pedal and rack chorus devices you have ever heard. 1.
1 2 3 4 5 11 10 9 6 7 8
4. Depth Knob Controls the depth of the chorus effect. Turn this knob clockwise to increase the depth for a thick chorus sound, and counter-clockwise to decrease the depth for a shallow, light chorus sound. 5.Voice Knob Controls the number of chorus voices used. At the knob’s minimum position, only a single chorus voice is present. As the knob is turned clockwise, more voices are brought in. At the maximum position of the Voice knob, 16 voices are heard interacting with one another. 6.
Push these pins in to release the pedal from the pedal chassis exposing the battery compartment. (See battery replacement diagram.) 8. Pedal Press the pedal to turn the effect on and off. 9. Out 1(Mono) Jack Connect this output to a single guitar amplifier when only one amp is being used. 10. Indicator LED This LED indicates when the effect is turned on. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. 11.
Connections The Multi Chorus has a single input and a pair of outputs. Out 1 is used if the Multi Chorus is being connected to only one amplifier. Out 2 is used for stereo operation. Connect Out 1 to the first amplifier and Out 2 to the second amplifier. The Multi Chorus also has built-in CIT™ cabinet modeling that can be enabled. This is a useful tool when running a distortion pedal into the Multi Chorus and then running direct into a mixer or recorder.
Battery Replacement 1. Using the tip of a 1/4” guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. 2. Remove the battery from the battery compartment and disconnect the battery cable. 3. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. 4. Place one hole of the pedal over its corresponding pin. 5.
SPECIFICATIONS: • Controls - Level, Speed, Depth,Voice, On/Off Pedal • Jacks - Input, Out 1 (Mono), Out 2 • Input Impedance - 1 MOhms • Output Impedance - 100 Ohms • Power Supply - 9V Alkaline Dry Battery • Power Consumption - 4.8Watts (w/optional PS200R power supply) • Battery Life - Approximately 4 hours (with continuous usage) • Dimensions - 4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H) • Weight - 1.38 lbs.