Owner's Manual

24
The 8-Position DIP Switch
The V-10 Power Block is configured using the 8-position DIP switch on the bottom of the
chassis. The easiest way to configure these 8 switches is to gather all required information
for your pedals, as described in the previous sections of this manual, and then input this
data into the “Pedal Requirements Reference Table” on page 22. You can then reference this
table and set the switches accordingly.
The table on the following page provides a description of each DIP switch setting. Each of
the 8 switches can be set to on or off, as shown below.
ON
1 2 3 4 5 6 7
8
ON
OFF