User`s guide

Modbus Profile: Serial-Connected Master
Chapter 4 Configure Industrial Automation (IA) 59
Modbus Profile: Serial-Connected Master
When to Use
Use this profile to connect a master device using Modbus RTU or Modbus
ASCII to the serial port of the device server.
Configuration Options
The serial port connection must be configured for the protocol required by
the master, in this case Modbus RTU or Modbus ASCII. If the remote slave
supports TCP socket communication, which is the case if the remote slave
is connected to another device server, Digi recommends this option.
Modbus/TCP is the other supported network option. This master can be
configured to control up to 8 slaves.
Setup Information
• To configure the port for Modbus ASCII or Modbus RTU and the
network for TCP socket communication, see "Configure a Serial-
Connected Master: TCP/UDP Sockets" on page 67.
• To configure the port for Modbus ASCII or Modbus RTU and the
network for Modbus/TCP, see "Configure a Serial-Connected Master:
Generic Procedure" on page 66.