User`s manual

Additional Products

To run the In-Premise Display/Meter Simulator sample (see page 30), you will also need

one of the following devices that has been converted to SE firmware. Full instructions

and firmware can be found in the ZB to SE conversion kit, which can be downloaded

from www.digi.com/X2SE or by clicking this link: http://ftp1.digi.com/support/images/zb-

to-smart-energy-conversion-kit.zip.

• XBee-PRO ZB USB adapter with internal wire antenna (part number XA-Z14-

CE1P-A). Available for purchase at http://www.digi.com/products/wireless/zigbee-

mesh/xbee-zb-adapters.jsp#models.

• XStick USB Adapter, ZB (part number XU-Z11). Available for purchase at http://

www.digi.com/products/wireless/zigbee-mesh/xbee-zb-adapters.jsp#models.

• XStick USB Adapter, SE (already configured with Smart Energy firmware (part

number XU-SE3). Available for purchase at

http://www.digi.com/products/

wireless/zigbee-mesh/xbee-zb-adapters.jsp#models, included in the ConnectPort

X2 for Smart Energy Starter Kit.

• Other serially-attached XBee if converted to SE firmware.

Note: The In-Premise Display/Meter Simulator sample only runs in Windows®