User`s manual

Parameter Type Description
status int Indicates the success or failure of the unbind request using standard
ZDO st
atus values. Can be success (0x00), not supported (0xAA), or
other
destination_address MAC 64-bit extended address of the device to which the ZDO bind request
wa
s sent
destination_endpoint_id int 8-bit identifier of the endpoint on the remote device on which the target
cl
uster exists
source_endpoint_id int 8-bit identifier of the endpoint on the local
device on which the target
cluster exists
cluster_id int 16-bit identifier of the cluster to be bo
und by the bind request
77
unbind_response Parameters:
configure_zigbee_network
Sets the parameters to join or form a network. Sending this command will cause the
gateway to reform or leave the current network it is joined to.
Parameter Type Description
extended_pan_id
(optional)
int If gateway is a coordinator - Exte
nded PAN ID of the network to
form. If set to zero, network will be formed on a random extended
PAN ID.
If gateway is a router - Ex
tended PAN ID of the network to join. If set
to zero, the gateway will not filter join attempts on extended PAN ID.
channel_mask
(optional)
int 16-bit bitmask of the channels to use for joining or forming a network.
Bit
s 0 - 16 map directly to channels 0x0B - 0x1A.
link_key (optional) int, base16 128-bit link key used to join a network.
installation_code
(optional)
int,
ba
se16,
string
48-, 64-, 96-, or 128-bit installation code hashed to generate a 128-bit
link key to join a network. Must include CRC as part of installation
code.
join_interval (optional) int Interval between join attempt
s for router. This parameter will also set
the registry_confirmation parameter
ZDO_Device_Manager.join_interval (see Registry on page 45.
configure_zigbee_network Parameters: