Installation manual
Table Of Contents
- About This Manual
- 1.0 Introduction
- 2.0 Installation
- 3.0 Scale Setup
- 4.0 Configuration Settings
- 5.0 Calibration
- 6.0 Scale Operations
- 7.0 Scale Programming
- 8.0 RS-232 Specifications
- 9.0 PC Connections and Label Formatting
- 10.0 Appendix
- 10.1 SPEC Code Worksheets
- 10.2 Scale Capacity and Display Resolution
- 10.3 Connector Pinouts
- 10.4 Cable Wiring
- 10.5 Y-Cable Wiring Diagram
- 10.6 DC-190 Messages
- 10.7 Clearing Locked-Up Scale (888888 Error)
- 10.8 DC-190 Character Code List (Teraoka Code)
- 10.9 Bar Code Board
- 10.10 PSC QuickScan 6000 Setup
- 10.11 DC-190 Ultra Count Specifications
- DC-190 Ultra Count Limited Warranty
RS-232 Specifications 43
8.11 Z Commands
Z command functions are usable when SPEC 14 and
SPEC 15 are set as noted in the table below allowing
as function key and are shown below.
Z Command Function
Z0 Rezero
Z1 Print
Z2 Unit weight clear
Z3 Plus
Z4 Minus
Z5 Tare
Z6 Clear
ZS1 Scale 1
ZS2 Scale 2
ZS3 Scale 3
ZS4 Scale 4
NOTE: SPEC 14, bit 3 (RS-232C Connection) must be
set to 1 (Yes) and SPEC 15, bit 2 (RS-232C with Header)
must be set to 0 (Yes) for the console to recognize the Z
commands.
Table 8-19. Z Command Functions