Installation guide

13
Verifying device support for commands
To verify whether a ConnectPort LTS device supports a particular command or command options, and to
get the allowed ranges and limits for command options, you can enter several commands. For example:
“help” displays all supported commands for a device.
“?” displays all supported commands for a device.
“set ?” displays the syntax and options for the “set” command. You can use this to determine whether
the device includes a particular “set” command variant.
“help set” displays syntax and options for the “set” command.
“set serial ?” displays the syntax and options for the “set serial” command.
“help set serial” displays the syntax and options for the “set serial” command.
Some options may become available in new firmware revisions or before new documentation is released.
Some commands relate only to particular features unique to specific Digi products. For example, the
“set wlan” command applies only to wireless products. Other commands may have options that are
specific to features that are not available on all devices.