Installation guide

75
[tcp keepalive options] are:
[idle=10-86400] (seconds)
[probe_count=5-30]
[probe_interval=10-75] (seconds)
[advanced ip options] are:
[reuse_old_op={off|on}]
[autoip={off|on}]
[sbr={off|on}]
Display current network configuration options
set network
Options index=1-4
Select index for Ethernet interface to configure. "index=1” is for setting
Ethernet interface 1(eth0) and "index=2” is for setting Ethernet interface
2(eth1). "index=3” and "index=4” are reserved for future use.
[ipv4 address options]
Set IP v4 address-related options for the ConnectPort LTS product,
including:
mode_v4={none|static|dhcp}
Sets the mode of device IP v4 address
none
Disable IPv4 address.
static
When selected, the device uses the specified IP address,
gateway address, and subnet mask.
dhcp
When selected, the device attempts to use the DHCP
protocol to find an IP address, gateway address, and
submask.
Default is “static” for Ethernet interface 1 and “none” for Ethernet
interface 2.