User manual

Software Installation 51
Equipment List
To see a display of installed components with their software and hardware revisions and status, the user types the
command letter “e” at the command prompt. There are four component types that can be displayed: motherboard,
line card, power supply and modem cards.
The motherboard and linecard components each have an ID byte, a hardware revision and a software revision. There
should only be one of each of these two components in a given modem bank.
The power supply component will display whether or not the primary and secondary power supply cards are working
and whether or not the secondary card is installed.
Finally, there will be from 1 to 4 modem card components listed. Each of these will have an ID byte and a hardware
revision.
An example of the equipment list screen is given below.
-----------------------------------------------------------------------------
Modem Bank Equipment List
-----------------------------------------------------------------------------
8 components found
slot type ID HW Rev SW Rev
-----------------------------------------------------
1 Modem Card 0x4D 0
2 Modem Card 0x4D 0
3 Modem Card 0x4D 0
4 Modem Card 0x4D 0
Motherboard 0x0 15 2.2
Line Card 0x54 0 1.53
Power Supply
Power Supply 2 is installed
Power Supply 1 is not working
Power Supply 2 is working
-----------------------------------------------------