Operation Manual

SM500MK4 Service Manual

4.5 Weigh & Measurement Spec Setup Procedure

To Change the setting of the Weight & Measurement SPEC, if there is some SPEC need to alter.

KEY TO PRESS OPERATION

In the Weighing Mode, press

then turn On the Span Switch.

-- Go to Z mode

KEY TO PRESS OPERATION

+ [1][4][2]

-- Go to Weight and Measure Specification Mode

-- To change the selection for the Spec, press the

Number of the selection.

-- Press ‘PRINT’ key to Save go to next Spec

-- Pres ‘-‘ key to go back to previous Spec

-- Press ‘PLU’ to save and exit

-- Press ‘Tare’ to exit without saving

KEY TO PRESS OPERATION

[0] To [1]

Then

-- Select data. (Refer to Weight & Measurement

Spec setting)

-- To choose scale type

-- To set. (Save data and increase SPEC No)

KEY TO PRESS OPERATION

-- Increase the SPEC number without saving data of

the previous SPEC number.