User guide

set user
238 Chapter 2 Command Descriptions
maxsessions=number
The maximum number of ports that a Telnet or Rlogin user can be logged
into at the same time. A value of 0 means that the user can be
simultaneously logged into all ports specified on the "ports" option.
menu={off|index num}
Specifies whether a menu is presented to the user, and if so, which
menu.
off and 0 (zero)
No menu is presented to the user.
index num
The menu, identified by an index number in the menu table, that will
be presented to this user.
The default is "off."
mtu=bytes
The maximum transmission unit (frame size in bytes) to use for this PPP
connection. For PPP connections, the MTU is negotiated, so enter 1500,
the largest size device server will permit the remote host to send. For
PPP users, the range is 128 to 1500 bytes, and the default is 1500 bytes.
n1,n2...=phone number
Up to 10 phone numbers to dial to request a PPP outgoing connection,
which dialer scripts reference. If you enter more than one phone number,
when the device server encounters a busy signal, it tries these numbers
in the order specified on this option. A phone number is required for
outbound PPP connections that use modems. You can enter phone
numbers as digits only, with dashes (-) separating digits, or with commas.
name=name
The name that identifies this user.
netrouting={off|send|rec|both}
Specifies how Routing Information Protocol (RIP) routing updates are
handled on connections to this PPP user. Use this option only if the user
is an IP router.
off
This user is not included in RIP updates.
send
Propagate RIP updates to this user, but do not accept RIP updates
from this user.
receive
Accept RIP updates from this user, but do not send RIP updates to this
user.
both
RIP updates will be sent to and received from this user.
The default is "off."