User`s guide

Configure Digi devices

123

Alternative configuration options for Digi Connect Wi-SP

If configuring the Digi Connect Wi-SP with a serial connection, there are several configuration

options.

Configure with an Access Point - Infrastructure Mode

1 Configure the network using an access point with the SSID - Connect and all encryption

disabled (such as WEP & WPA).

2 Power up the device.

3 Launch the Discovery program and proceed with the configuration.

Configure without an Access Point - Laptop with a Wireless Card Ad-Hoc Mode

1 Configure the wireless card to operate in Ad-Hoc mode with the SSID - Connect.

2 Power up the device.

3 Launch the Discovery application on the laptop and proceed with the configuration.

Command line access

Note

To set the DIP switches on the Digi Connect Wi-SP (or SP), ALWAYS disconnect the

power supply before resetting the switches. See the following procedure for more

details.

1 Disconnect the power supply.

2 Set the Digi Connect Wi-SP DIP switches in the On or up position. The figure shows DIP

Switch settings for Command Line access for both the Digi Connect Wi-SP and the Digi

Connect SP.

3 Connect the Digi Connect Wi-SP to a PC with a serial cable.

4 Access a terminal emulation program such as HyperTerm.

Choose Start > Accessories > Communication > Hyperterm and enter a name for the

connection.

1234