EX-007 User Manual ISSUE A - JANUARY 2010
EX-007 User Manual Contents 1.1 Overview .............................................................................................. 3 1.2 Connections ........................................................................................ 3 1.3 Viewing the Master Screen ................................................................ 4 1.4 Network Setup .................................................................................... 4 1.5 Mirroring Mode..............................................
EX-007 User Manual 1.1 Overview .................................................................................. These instructions must be read in conjunction with the current SD-7 User Manual and Mach2 Upgrade Appendix. The EX-007 provides worksurface expansion for the DiGiCo SD-7 console. It consists of two, twelve fader channel sections that have all the same functionality as the left and right channel sections of the SD-7 worksurface.
EX-007 User Manual 1.3 Viewing the Master Screen..................................................... When setting up the network between the SD-7 and EX-007, it is useful to be able to view the Master Screen on the EX-007. To do this, press either the left section Rotary Resolution button or the keyboard F5 key. Pressing either of these buttons again will return the screen to a Channel view. Moving a Channel control or Assignable rotary will also return the screen to a channel view.
EX-007 User Manual 1) Load the required session on the SD-7 Engine A 2) Press the Select button in the Network panel for SD-7 Engine B 3) Press the Send Session To Selected button to transfer the session to SD-7 Engine B and wait for the process to complete 4) Press the Select button in the Network panel for EX-007 in the Remotes section of the Network panel 5) Press the Send Session To Selected button to transfer the session to the EX-007 and wait for the process to complete 6) Press the Select button in
EX-007 User Manual 1.5 Mirroring Mode ........................................................................ Mirrored devices may operate in one of 3 different modes which are set in the Master screen / Options / Session tab. Mirroring Modes are: 1) Full Mirror - normally used between two SD-7 engines where all functions are mirrored to ensure that the two sessions remain in complete sync.