User Manual
Table Of Contents
- Contents (Appendix A)
- A1.1 Optocore V221 - Introduction .......
- A1.1.1 System Overview .......
- A1.1.2 Opto V220 (DiGiRacks) and Opto V221 (SD Racks) .......
- A1.1.3 Replacing DiGiRacks with SD Racks .......
- A1.1.4 Replacing SD Racks with DiGiRacks .......
- A2.1 The Audio IO Panel .......
- A2.1.1 Layout .......
- A2.1.2 Quick Start Guide for SD V370+ and Optocore V221 .......
- A2.1.3 Audio Sync .......
- A2.1.4 The Port List .......
- A2.1.5 Managing Ports .......
- A2.1.6 SD Rack Splits .......
- A3.1 SD Series Dual Loop Optocore Systems .......
- A3.1.1 Important Considerations .......
- A3.2.1 Setting up a Dual Loop System .......
- A3.2.2 Console Snd/Rcv Ports .......
- A3.2.3 Single Loop Console on Loop 2 .......
DiGiCo Optocore V221
A1-15
A3.2.4 Single Loop Console on Loop 2 ........................................
SD8, SD9, SD10 and SD11 consoles are only able to have connections fitted one loop and the internal connections within the
console will be to loop 1.
In the Options>Console menu, the Enable Optocore option allows the console to either be a loop 1 console or loop 2 console
(shown below) without having to alter the internal connections.
Single loop consoles operate independently on each loop. For example, a system can exist of a dual loop SD7 (IDs 1+2), an SD8
(ID3) on loop 1 and an SD10 (also ID3) on loop 2.
SD5s & SD7s that only have a single loop fitted can also set to operate on either Loop 1 or Loop 2.