Owner's manual

SD7 - Getting Started

1-12

1.5.8 Manual Conforming of Racks...............................................

With a Rack selected in the left hand port selection list, the window will look something like the image below, depending on the

cards installed in the connected rack. The graphic shows the 14 available cards/slots, 7 input & 7 output.

Edit the Port Name here.

Eg. Stage Rack, Local Rack etc...

Select Card Type manually or

using Auto-Conform function,

and edit Group Name

Selected Socket Properties

Edit Name and Socket options.

uto Conforming for all ports,

ndividual racks,

r individual cards

Select the contents of the bottom-right

corner of the Audio IO window

Select the port to be configured

Copy Rack Audio to MADI

In order to use the rack, the on-screen contents of the rack must match the cards physically installed in the rack connected. This

is normally acheived by pressing the Conform All Ports button but can also be acheived manually if necessary.

Select each card (column) and manually select the appropriate card in the Card/Slot Type drop down menu in the lower section of

the window (displayed when the Cards & Sockets button towards the bottom-left is selected). Once the correct card type is

selected, the Label at the bottom the selected card will turn green, indicating the card type matches the card installed in the rack. If

the Card Type name is Red, then there is a mismatch, and the error should be corrected by selecting the correct card type.

Copying Audio and Listening to Copied Audio (MADI Recorder Setup)

Audio from a Rack can be copied to the MADI Port Output by selecting the incoming Port in the Ports list and using the Copy Audio

To drop down menu. For example, if you want to copy the Rack Audio Inputs to a recorder connected over MADI, select Rack 1

in the ports list and then select MADI from the Copy Audio To drop down menu. The 56 inputs on Rack 1 will be copied to the

SD7 MADI output.

In addition, by connecting the recorder's MADI Output to the SD7 MADI Input, the playback can be monitored in the same channels

as the original source material. Just press the Listen To Copied Audio button to monitor playback and press it again to return to

monitoring the live sources from the rack.

Standard MADI Connections

If you have a standard MADI connection (not a DiGiCo Rack) to your SD7, you can set the console to display the MADI with

generic signal names, i.e. MADI 1, MADI 2.. etc. through to MADI 56 (or 64) instead of the usual rack style names. The naming does

not affect the signal, but makes routing signals easier.

Unrouting All Outputs

All outputs to the selected port can be unrouted at once by pressing the unroute all outputs button below the cards graphic

and selecting yes in the warning pop-up which appears. "Copied" audio is not unrouted by this action.

Note that this will cancel all routing created in the channel screens and cannot be undone.