Setup guide

Output Trim settings are irrelevant to the Delta-Link because its inputs and outputs are all digital. We can therefore use
t
he Analog Out tab of the Pro Tools software’s Hardware Setup window to control internal Delta-Link settings.
Page 9
33
. Make sure the first 192 is
selected while you change
settings, as the Delta-Link is
controlled via Primary Port A.
44
. Click the Analog Out tab, then apply the following settings:
• Set Ch 1 to ‘A’ to match the Alpha-Links setting, which defaults to 56
MADI channels (or see the manual to switch the Alpha-Links to 64 MADI
channels).
•
Set Ch 2 to ‘B’. This selects the Delta-Link ‘Special Mode’, so that each
primary port is linked to one MADI port (in ‘Normal Mode’, the output
signals from both the Core and Accel cards would be duplicated on the
outputs of both Alpha-Links, but the signals received on the Alpha-Link
2 inputs would not reach Pro Tools!)
• Ch 3 to Ch 8 should be set to ‘A’.
55
. When ready, click OK to exit the
Hardware Setup and save your settings.