User Manual

D i g i g r a m
10
Serial port (RS232 on DB9)
ES881, ES1241, and ES16161 dispose of a serial ES16161 RS232 male port on the rear panel. Use this port to
connect any compatible device. For pinout allocation details, please refer to the figure and table above.
Note: The RS232 serial port management requires specific software.
Remote set-up by means of configuration software
Use of the configuration software allows for the management of all devices on the EtherSound network; for
software details, please refer to the on-line help file.
ES881, ES1241, and ES16161 are shipped with a CD-ROM containing the EtherSound driver and the
Digigram configuration software, EScontrol. To install this software, you must first add the EtherSound driver
to your system. A window lists the instructions you must follow to achieve this step.
Next, launch setup.exe on a PC connected to an EtherSound network. An InstallShield Wizard will guide you
through the installation process.
ES881, ES1241, and ES16161 may also be managed through configuration software edited by Digigram
development partners.
To uninstall the software go to Add/Remove programs in the Windows Control Panel.
Firmware update
Digigram may decide to publish firmware updates. It may then become necessary to upgrade your devices. In
this case please refer to the respective documentation provided with the firmware upgrade tool.
Pin # Description
1
not connected
2
RxD (received data)
3
TxD (transmitted data)
4
not connected
5
signal ground
6
not connected
7
RTS (request to send)
8
CTS (clear to send)
9
not connected