User Manual

Click on to set the global parameters of CANCUN.

Cards: allows select the CANCUN device to set its parameters.

Clocks: allows selecting the sampling clock:

· Internal: sampling clock is generated internally

· AES1: sampling clock is extracted from digital input AES1.

Without digital signal connected to the input “AES 1”, AES1

clock selection is displayed as “not valid”.

Buffers: these parameters allow adjusting the latency of the

CANCUN device.

· Streaming: this is the lowest level of buffering, which impacts the

latency in DirectSound as well as in ASIO.

Possible selections are: min latency, low latency, standard, relax,

safe, extra safe.

· ASIO: this is the buffering used by the ASIO driver, in samples.

Possible values are: 64, 128, 256, 512, 1024, 2048, 4096, 8192

samples.

The minimum selectable value depends on the

parameter “Streaming”.

When “Streaming” is set to “low latency” , all values are allowed.

When “Streaming” is set to “extra safe”, values higher or equal to

2048 samples can be selected.

Note: minimum latency settings require good PC performances.

Configuration Save

Click on “Save” to save the current parameter configuration (settings

are saved as an XML file).

Configuration Restore

Click on “Restore” to load presets (XML file).

Opacity: this parameter allows adjusting the transparency of the

Control Panel GUI. Available choices are: opaque, 30%, 50%.

Note:

- This panel is opened when selecting the “ASIO configuration” from

an ASIO software application.

- Be aware that certain applications (e.g. Reaper) do not allow

direct editing of CANCUN configuration menu; in this case, the

CANCUN menu should be accessed through the application audio

configuration menu which in turn launches CANCUN panel.

Configuration of audio inputs parameters

Adjusting the gains on the analog inputs and displaying vu-meters