User Manual

D i g i g r a m

INFORMATION FOR THE USER

This device complies with part 15 of FCC rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a CLASS B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions contained in this data sheet, may

cause harmful interference to radio and television communications. However, there is

no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

* reorient or relocate the receiving antenna

* increase the separation between the equipment and the receiver

* connect the equipment into an outlet on a circuit different from that of the receiver

* consult the dealer or an experienced audio television technician.

Note:

Connecting this device to peripheral devices that do not comply with CLASS B

requirements or using an unshielded peripheral data cable could also result in

harmful interference to radio or television reception. The user is cautioned that any

changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment. To ensure

that the use of this product does not contribute to interference, it is necessary to use

shielded I/O cables.

No portion of this manual may be reproduced without prior written consent from Digigram. The copyright protection

claimed here includes photocopying, translation and/or reformatting of the information contained in this manual.

While every effort has been made to ensure accuracy, Digigram is not responsible for errors and omissions, and

reserves the right to make improvements or changes in the products and programs described without notice.

Digigram VX881HR and VX882HR are registered trademarks or trademarks of Digigram S.A. Other trademarks are

property of their respective holders.