User Manual

DigiGrid M

7.2 Patching I/O to Driver and Driver to I/O

When streaming audio to and from an DiGiGrid M and a DAW, you must assign DiGiGrid M inputs and outputs to the SoundGrid

ASIO/Core Audio driver. (Alternatively, you may choose to monitor through the eMotion ST mixer. We’ll cover that option later in this

section.)

In the SoundGrid Studio Patch page, select the Device-to-Device tab. All device and driver channels are shown along both the

horizontal and vertical axes. To make a standard “ascending patch” connection, draw the cursor in a diagonal line as shown below.

To create a customized patch, click on individual cells. There are many ways to patch devices, but normally DiGiGrid M inputs are

patched to the ASIO/Core Audio inputs for recording. For playback, the patches are opposite, unless you choose to patch to the

eMotion ST mixer for monitor mixing.

Once again, if you set up your system using the Wizard, you will not need to do any of this.