User manual

OpenScope MZ Acrylic Case Assembly Manual 4
Assembly Instructions
NOTE: For simplicity, the acrylic case can be assembled upside down on a counter top. Do not pick up
the case from the counter top until the final step, otherwise the screws will fall out of place. Pay
attention on each layer to see which side is up throughout the assembly instructions.
Step 1:
Place the four screws through the screw holes on LAYER 1, then lay the acrylic piece along with the
screws on a counter top surface so that the screw heads are touching the counter.
Step 2:
Slide LAYER 2A and LAYER 2B through the screw holes as shown below, keeping the case still on the
counter top. Set this assembly aside, it will be needed once again in Step 4.