User manual

OpenScope MZ Acrylic Case Assembly Manual 5
Step 3:
With the previous assembly aside, LAYER 3 will be assembled separately first, and then will be included
with the rest of the case in Step 4. Using Layer 3 and the OpenScope MZ board, carefully place the
OpenScope MZ board within the acrylic groove without bending the acrylic. Make sure that the top
surface of the board is flush with the surface of the acrylic.
Make sure the micro USB connector lines up with the micro USB notch on the acrylic piece, this will
ensure the correct orientation.
Top View
Two Top Surfaces Flush
Fr
Micro USB Acrylic Notch
Fr