User manual

OpenScope MZ Acrylic Case Assembly Manual 7
Pay attention to the micro SD card cutout and align the acrylic piece so that they lay flush along the slot.
If you notice that they are not flush, flip the LAYER 4 and see if it fixes the issue.
Step 6:
With the provided hex nuts, screw on the nuts to the ends of the screws by hand, and then align the
four layers so that they remain flush on all four sides. Do this by gripping your hand together with your
fingers located on each side. Finish tighten the screws with the Philips screw driver.
Align Micro SD Card Slot
Based on Previous Layer
Compress with Hand
from Each Side
All Four Layers Flush