Datasheet
• Part# 310-035P
UART Crossover Cable
• 6", 6-pin crossover cable
• Connects newer UART-interface Pmods (PmodBT) to older microcontroller boards (Cerebot
2, Cerebot 32MX4, etc.)
• Connects older UART-interface Pmods (PmodCLS, PmodRS232, etc.) to newer
microcontroller boards (Coming soon)
• For more information on where / how to use this cable, please see this document.
• Part# 250-047
VHDCI Male-to-Male Cable
• VHDCI male connector on both ends
• 16" in length
• Useful for connecting Vmods to VHDCI-equipped system boards (Genesys, Atlys, ...)
• Part# 250-045P
HDMI Cable (Type A to Type A)
• 40" in length
• Part# 240-053P
HDMI Cable (Type A to Type D micro)
• 40" in length
• Part# 310-051P
6 Pin Cable Connector
• available in lengths of 6", 12", and 18"
• designed for use with Digilent peripheral modules
• can be used to send FPGA signals to an outside device
• 6-pin connectors are standard 100mil spaced 25mil square connectors
• allow signals to be routed to and from an FPGA on a Digilent system board
• Part# 310-009 / 310-034 / 310-010
2x6 Pin Cable
• Designed to connect a 12-pin Pmod to a 12-pin system board connector
• Can be used to send Digilent System board signals to and from outside devices
• Uses standard 100mil-spaced 25mil square connectors
• 7" (18mm) in length
• Part# 250-032P
2x6 Pin to Dual 6 Pin Cable
• Designed for use with Digilent Peripheral Modules that have 2x6 pin connectors
• Designed to connect two 6-pin system board connectors to a 12-pin Pmod connector, or to
connect a 12-pin system board connector to two 6-pin Pmod connectors
• Uses standard 100mil-spaced 25mil square connectors
• 7" (18mm) in length
• Part# 250-030
6Pin Header & Gender Changer
• Changes gender for any 6 pin female header, female to male
• Connects any 2 digilent 6 pin cables together
• Provides easy access for test and measurement
• Ships in pack of 5
• Part# 240-004
PICkit3 Programming Cable Kit
• For connecting a chipKIT™ board to Microchip's PICkit3 debugger/programmer.
®
Page 4 of 6