Datasheet

1300 Henley Court

Pullman, WA 99163

509.334.6306

www.digilentinc.com

PmodCON1™ Reference Manual

Revised May 24, 2016

This manual applies to the PmodCON1 rev. B

DOC#: 502-065

Other product and company names mentioned may be trademarks of their respective owners.

Page 1 of 2

Overview

The PmodCON1 is a module that allows your system board to interface to other components via screw terminals.

1 Functional Description

Screw terminals provide two features that are not easily offered by pin headers. With their large surface area, it is

easy to pass larger amounts of power through them without running the risk of having them overheat.

Additionally, with the ability to screw down onto wires, it is possible to attach this Pmod to objects that otherwise

could not be attached to a breadboard or conveniently soldered.

2 Interfacing with the Pmod

Through its GPIO interface, you can easily send out a high or low voltage signal from a pin on the system board

and have it get sent straight to the appropriate screw terminal.

The PmodCON1.

 Six screw terminals

 Four screw terminals for data signals

 Two screw terminals for external power

 Small PCB size for flexible designs 1.1“ × 0.8” (2.8

cm × 2.0 cm)

 6-pin Pmod connector with GPIO interface

 Follows Digilent Pmod Interface Specification Type

Features include:

PAGE 1
300 Henley Court Pullman, WA 99163 509.334.6306 www.digilentinc.com PmodCON1™ Reference Manual Revised May 24, 2016 This manual applies to the PmodCON1 rev. B Overview The PmodCON1 is a module that allows your system board to interface to other components via screw terminals. Features include:       Six screw terminals Four screw terminals for data signals Two screw terminals for external power Small PCB size for flexible designs 1.1“ × 0.8” (2.8 cm × 2.
PAGE 2
PmodCON1™ Reference Manual Pin Number 1 2 3 4 5 6 Descriptions Screw Terminal P1 Screw Terminal P2 Screw Terminal P3 Screw Terminal P4 Ground Screw Terminal VCC Screw Terminal Table 1. Pin descriptions. Note that the two screw terminals that are designated for a positive and ground power supply act in only one direction.