Datasheet

1300 Henley Court

Pullman, WA 99163

509.334.6306

www.digilentinc.com

PmodUSBUART™ Reference Manual

Revised April 10, 2015

This manual applies to the PmodUSBUART rev. A

DOC#: 502-212

Other product and company names mentioned may be trademarks of their respective owners.

Page 1 of 2

Overview

The PmodUSBUART module provides a USB to UART interface powered by the FTDI FT232RQ. This Pmod is

designed to be a direct replacement for the PmodRS232 and serial-to-USB cable combination.

1 Functional Description

The PmodUSBUART uses the standard 6-pin connector to connect to the host device and a micro USB connector to

connect to a PC or other USB-capable device. The FTDI chip then converts the signal from UART to USB and vice-

versa.

2 Interfacing with the Pmod

The UART connector allows UART communications to go from the FTDI chip to the connected board. Note that the

PmodUSBUART uses the new Digilent UART pin configuration and requires the UART Crossover cable in order to

use older boards. To see what configuration your board has, see your board's page at http://store.digilentinc.com.

The PmodUSBUART.

 USB to serial UART interface

 Option to power the system board through

the FTDI chip

Features include:

PAGE 1
300 Henley Court Pullman, WA 99163 509.334.6306 www.digilentinc.com PmodUSBUART™ Reference Manual Revised April 10, 2015 This manual applies to the PmodUSBUART rev. A Overview The PmodUSBUART module provides a USB to UART interface powered by the FTDI FT232RQ. This Pmod is designed to be a direct replacement for the PmodRS232 and serial-to-USB cable combination. Features include:   USB to serial UART interface Option to power the system board through the FTDI chip The PmodUSBUART.
PAGE 2
PmodUSBUART™ Reference Manual Connector J2 – UART Communications Pin Signal Description 1 RTS Ready to Send 2 RXD Receive 3 TXD Transmit 4 5 6 CTS GND SYS3V3 Clear to Send Ground Power Supply (3.3V) Table 1. Pinout description table. 3 SYS3V3 Select (Header JP1) The board attached to the PmodUSBUART can have its 3.3V rail powered by the header JP1. If jumper JP1 is set to SYS, then the SYS3V3 pin is powered by the VCC outputted by the FTDI chip.