Datasheet

PmodGYRO™ Reference Manual
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page 3 of 3
2.1 Pinout Description Table
Header J1
Header J2
Pin
Signal
Description
Pin
Signal
Description
Pin
Signal
Description
1
~CS
Chip Select
7
INT1
Interrupt 1
1,
5
SCL
Serial Clock
2
MOSI
Master-Out-Slave-
In
8
INT2
Interrupt 2
2,
6
SDA
Serial Data
3
MISO
Master-In-Slave-
Out
9
(NC)
Not Connected
3,
7
GND
Power Supply
Ground
4
SCLK
Serial Clock
10
(NC)
Not Connected
4,
8
VCC
Positive Power
Supply (3.3V)
5
GND
Power Supply
Ground
11
GND
Power Supply
Ground
6
VCC
Positive Power
Supply (3.3V)
12
VCC
Positive Power
Supply (3.3V)
Table 2. Pinout description table.
Any external power applied to the PmodGYRO must be within 2.4V and 3.6V; however, it is recommended that
Pmod is operated at 3.3V.
3 Physical Dimensions
The pins on the pin header are spaced 100 mil apart. The PCB is 1 inch long on the sides parallel to the pins on the
pin header and 0.8 inches long on the sides perpendicular to the pin header.