Datasheet

 2009-2016 Microchip Technology Inc. DS60001156J-page 279
PIC32MX5XX/6XX/7XX
25.0 ETHERNET CONTROLLER
The Ethernet controller is a bus master module that
interfaces with an off-chip Physical Layer (PHY) to
implement a complete Ethernet node in a system.
Key features of the Ethernet Controller include:
• Supports 10/100 Mbps data transfer rates
• Supports full-duplex and half-duplex operation
• Supports RMII and MII PHY interface
• Supports MIIM PHY management interface
• Supports both manual and automatic Flow Control
• RAM descriptor-based DMA operation for both
receive and transmit path
• Fully configurable interrupts
• Configurable receive packet filtering
- CRC check
- 64-byte pattern match
- Broadcast, multicast and unicast packets
- Magic Packet™
- 64-bit hash table
- Runt packet
• Supports packet payload checksum calculation
• Supports various hardware statistics counters
Figure 25-1 illustrates a block diagram of the Ethernet
controller.
FIGURE 25-1: ETHERNET CONTROLLER BLOCK DIAGRAM
Note: This data sheet summarizes the features
of the PIC32MX5XX/6XX/7XX family of
devices. It is not intended to be a
comprehensive reference source. To
complement the information in this data
sheet, refer to Section 35. “Ethernet
Controller” (DS60001155) in the “PIC32
Family Reference Manual”, which is avail-
able from the Microchip web site
(www.microchip.com/PIC32).
TX Bus
Master
System Bus
RX Bus
Master
TX DMA
TX Flow Control
Host IF
RX DMA
RX Filter
Checksum
MAC
External
PHY
MII/RMII
IF
MIIM
IF
MAC Control
and
Configuration
Registers
TX Function
RX Function
DMA
Control
Registers
Fast Peripheral
Bus
Ethernet Controller
RX Flow
Control
Ethernet DMA
RX BM
TX BM
TX
FIFO
RX
FIFO