Information

Nexys4 DDR™ FPGA Board Reference Manual

Other product and company names mentioned may be trademarks of their respective owners.

Page 10 of 29

clocking resources that can be inserted into the user’s design. The clocking wizard can be accessed from within the

Project Navigator or Core Generator tools.

7 USB-UART Bridge (Serial Port)

The Nexys4 DDR includes an FTDI FT2232HQ USB-UART bridge (attached to connector J6) that allows you use PC

applications to communicate with the board using standard Windows COM port commands. Free USB-COM port

drivers, available from www.ftdichip.com under the "Virtual Com Port" or VCP heading, convert USB packets to

UART/serial port data. Serial port data is exchanged with the FPGA using a two-wire serial port (TXD/RXD) and

optional hardware flow control (RTS/CTS). After the drivers are installed, I/O commands can be used from the PC

directed to the COM port to produce serial data traffic on the C4 and D4 FPGA pins.

Two on-board status LEDs provide visual feedback on traffic flowing through the port: the transmit LED (LD20) and

the receive LED (LD19). Signal names that imply direction are from the point-of-view of the DTE (Data Terminal

Equipment), in this case the PC.

The FT2232HQ is also used as the controller for the Digilent USB-JTAG circuitry, but the USB-UART and USB-JTAG

functions behave entirely independent of one another. Programmers interested in using the UART functionality of

the FT2232 within their design do not need to worry about the JTAG circuitry interfering with the UART data

transfers, and vice-versa. The combination of these two features into a single device allows the Nexys4 DDR to be

programmed, communicated with via UART, and powered from a computer attached with a single Micro USB

cable.

The connections between the FT2232HQ and the Artix-7 are shown in Figure 6.

TXD C4

Micro-USB

(J6)

RXD

Artix-7FT2232

CTS

RTS

JTAG

Figure 6. Nexys4 DDR FT2232HQ connections.

8 USB HID Host

The Auxiliary Function microcontroller (Microchip PIC24FJ128) provides the Nexys4 DDR with USB Embedded HID

host capability. After power-up, the microcontroller is in configuration mode, either downloading a bitstream to

the FPGA, or waiting to be programmed from other sources. Once the FPGA is programmed, the microcontroller

switches to application mode, which is USB HID Host in this case. Firmware in the microcontroller can drive a

mouse or a keyboard attached to the type A USB connector at J5 labeled "USB Host”. Hub support is not currently

available, so only a single mouse or a single keyboard can be used. Only keyboards and mice supporting the Boot

HID interface are supported. The PIC24 drives several signals into the FPGA – two are used to implement a

standard PS/2 interface for communication with a mouse or keyboard, and the others are connected to the FPGA’s

two-wire serial programming port, so the FPGA can be programmed from a file stored on a USB pen drive or

microSD card.