User manual
Basys MX3™ Board Reference Manual
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page 21 of 56
Figure 7.1. Seven-segment schematic diagram.
The anodes of the seven LEDs forming each digit are tied together into one “common anode” circuit node, but the
LED cathodes remain separate, as shown in Fig. 7.2. The common anode signals are available as four “digit enable”
input signals to the 4-digit display. The cathodes of similar segments on all four displays are connected into seven
circuit nodes labeled CA through CG (so, for example, the four “D” cathodes from the four digits are grouped
together into a single circuit node called “CD”). These seven cathode signals are available as inputs to the 4-digit
display. This signal connection scheme creates a multiplexed display, where the cathode signals are common to all
digits but they can only illuminate the segments of the digit whose corresponding anode signal is asserted.
Figure 7.2. Seven-segment digits.
To illuminate a segment, the anode should be driven high while the cathode is driven low; however, since the
Basys MX3 uses transistors to drive enough current into the common anode point, the anode enables are inverted.
Therefore, both the AN0 … AN3 and the CA … G/DP signals are driven low when active.
Figure 7.3. Common anode circuit node.