Datasheet

1300 Henley Court

Pullman, WA 99163

509.334.6306

www.digilentinc.com

Pmod SSR Reference Manual

Revised January

This manual applies to the Pmod SSR rev. B

DOC#: 510-430

Other product and company names mentioned may be trademarks of their respective owners.

Page 1 of 2

Overview

The Digilent Pmod SSR (Revision B) is a solid state relay that features IXYS' CPC1908J. The Pmod SSR uses a switch

controlled by a single GPIO pin and is rated to block up to 60 Volts and pass up to 15 Amps.

1 Functional Description

The Pmod SSR uses a single GPIO pin to establish a connection between two terminals.

2 Specifications

Parameter

Rating

Units

Maximum Blocking Voltage

Maximum Peak Current

Maximum Continuous Current

rms

On-resistance

0.09-0.3

Ω

Turn-on Switching Speed

Turn-off Switching Speed

The Pmod SSR.

 Solid State Relay electronic switch

 Open/closed status LED

 1×6-pin Pmod port with GPIO interface

Features:

PAGE 1
300 Henley Court Pullman, WA 99163 509.334.6306 www.digilentinc.com Pmod SSR Reference Manual Revised January This manual applies to the Pmod SSR rev. B Overview The Digilent Pmod SSR (Revision B) is a solid state relay that features IXYS' CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 60 Volts and pass up to 15 Amps. Features:    Solid State Relay electronic switch Open/closed status LED 1×6-pin Pmod port with GPIO interface The Pmod SSR.
PAGE 2
Pmod SSR Reference Manual 3 Interfacing with the Pmod The Pmod SSR communicates with the host board via a GPIO pin. To open the relay, the ON pin must be driven to a logic high state. To close the relay, the ON pin must be driven to a logic low state. 3.1 Pinout Description Table Pin 1 2 3 4 5 6 4 Signal ON NC NC NC GND VCC Description Switch Control Not Connected Not Connected Not Connected Power Supply Ground Power Supply (3.