Product Guide

PRODUCT GUIDE
Mini/Standard/Hybrid Touch-Free RFID
|
Basic & Advanced
7
PRODUCT GUIDE
Mini/Standard/Hybrid Touch-Free RFID
|
Basic & Advanced
6
PROGRAMMING INSTRUCTIONS - IN ASSIGNED USE FUNCTIONALITY
Assign User Credentials
Up to 20 user credentials (User Key or RFID Credential) may be assigned to each lock.
Present hand to wake up lock. Insert a valid Manager Key for
5 seconds. Two sets of two-
tone beeps will be heard.
Remove the Manager Key.
The LED will turn on.
Insert each User Key or
present each User RFID
Credential one at a time.
Two sets of two-tone beeps
will be heard for each user
credential assigned to the
lock.
Insert a valid Manager Key.
A two-tone beep will be
heard and the LED will turn
off.
or
Express Register User and Manager Credentials
The Programming Key can quickly program multiple locks to operate with the same user and manager credentials.
Go to a lock already programmed to operate with the user and
manager credentials.
Insert Programming Key and hold for 15 seconds (a two-tone
beep will be heard after 5 seconds followed by 2 sets of two-
tone beeps after 10 seconds followed by 3 sets of two-tone
beeps after 15 seconds).
The LED will ash.
Remove and reinsert the Programming Key.
A two-tone beep will be heard and the LED will turn off.
Insert the Programming Key to program each lock to operate
with the same user and manager credentials.
Two sets of two-tone beeps will be heard and the LED will ash
once to indicate successful programming.
End express registration.*
Go to any programmed lock.
Present hand to lock until a single beep is heard, then insert the
Programming Key to operate the lock.
4b
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
1
3
2
4a
1
2
3
4
PROGRAMMING INSTRUCTIONS - IN ASSIGNED USE FUNCTIONALITY
Remove User Credentials (for assigned use functionality only)
Make sure the lock is in assigned use functionality (a green LED will ash when presenting hand to lock). The locks must be
reprogrammed to remove user credentials from operating a lock.
Collect all remaining and replacement user credentials Present hand to wake up the lock.
Insert Manager Key and hold for 5 seconds, a two-tone beep will
be heard.
The LED will turn on.
Remove and insert Manager Key again.
Three sets of two-tone beeps will be heard and the LED will turn
off.
All previously assigned user credentials will be removed.
Follow Assign User Credentials instructions to assign the
remaining and replacement user credentials to the locks.
1
3
2a
2b