DH200+ FAQ
Table Of Contents
- Frequently Asked Questions: DH200+ Series
- 1. Press the MENU button on the front panel, remote control, or virtual remote to open the main menu.
- 2. From the main menu, click RECORD ().
- 3. Configure the following for the channel you wish to enable motion:
- 4. Click to save your settings.
- 1. From the main menu, click CAMERA ().
- 2. From the camera section tab, click on the camera that has motion enabled.
- Select camera
- Select all
- "RATE" is set to 15 F/S. This means the system will record at 15 FPS during continuous recording.
- Motion is set to ON. This means the system will start motion recording when the system detects motion.
- Enter the desired recording frame rate during Motion recording
- 3. Click to save your settings
- NOTE: If you change your default port number a different port, you still need to enter your port number after the DDNS address.
- 1. In Internet Explorer, enter your DVR’s DDNS address, followed by /webserver
- 2. Enter the DVR’s user name and password and then click OK.
- 3. Click on the ActiveX toolbar, and click Install ActiveXControl.
- 4. At the Security Warning prompt, click Install.
- 5. Click Next to install the Web Server software. Click Close to complete the installation.
- Up arrow
2
Frequently Asked Questions: DH200
+
Series
Step 2 of 3 (OPTIONAL): Configure motion detection areas
By default, the entire channel area is selected for motion recording. Follow the steps below to
customize the area of the channel that you wish to enable motion recording.
1. From the main menu, click CAMERA ( ).
2. From the camera section tab, click on the camera that has motion enabled.
3. Beside MOTION GRID, use the buttons to select all, or select a certain
portion of the screen that will detect motion. In the motion grid, you can select the areas that
you wish to monitor for motion.
NOTE: If you use Custom Select, double-click the Motion Grid on the area that you wish to
enable motion. Motion activated areas highlight with a blue grid.
4. Click to save your settings.
Select camera
Select all
Custom Select
De-select all
Motion Grid