DH200+ FAQ
Table Of Contents
- Frequently Asked Questions: DH200+ Series
- 1. Press the MENU button on the front panel, remote control, or virtual remote to open the main menu.
- 2. From the main menu, click RECORD ().
- 3. Configure the following for the channel you wish to enable motion:
- 4. Click to save your settings.
- 1. From the main menu, click CAMERA ().
- 2. From the camera section tab, click on the camera that has motion enabled.
- Select camera
- Select all
- "RATE" is set to 15 F/S. This means the system will record at 15 FPS during continuous recording.
- Motion is set to ON. This means the system will start motion recording when the system detects motion.
- Enter the desired recording frame rate during Motion recording
- 3. Click to save your settings
- NOTE: If you change your default port number a different port, you still need to enter your port number after the DDNS address.
- 1. In Internet Explorer, enter your DVR’s DDNS address, followed by /webserver
- 2. Enter the DVR’s user name and password and then click OK.
- 3. Click on the ActiveX toolbar, and click Install ActiveXControl.
- 4. At the Security Warning prompt, click Install.
- 5. Click Next to install the Web Server software. Click Close to complete the installation.
- Up arrow
6
Frequently Asked Questions: DH200
+
Series
How do I access the DVR’s Web Server feature?
To access the system’s Web Server feature, add : /webserver to the end of your DDNS address.
For example, if your DDNS address is http://tomsmith.digimerge.net:80 , you will have to enter
the following to access the Web Server feature: http://tomsmith.digimerge.net:80/webserver
The Web Server feature allows you to configure your DVR menus and settings remotely.
Web Server Installation Steps
1. In Internet Explorer, enter your DVR’s DDNS address, followed by /webserver
2. Enter the DVR’s user name and password and then click OK.
3. Click on the ActiveX toolbar, and click Install ActiveXControl.
4. At the Security Warning prompt, click Install.