DH200+ FAQ
Table Of Contents
- Frequently Asked Questions: DH200+ Series
- 1. Press the MENU button on the front panel, remote control, or virtual remote to open the main menu.
- 2. From the main menu, click RECORD ().
- 3. Configure the following for the channel you wish to enable motion:
- 4. Click to save your settings.
- 1. From the main menu, click CAMERA ().
- 2. From the camera section tab, click on the camera that has motion enabled.
- Select camera
- Select all
- "RATE" is set to 15 F/S. This means the system will record at 15 FPS during continuous recording.
- Motion is set to ON. This means the system will start motion recording when the system detects motion.
- Enter the desired recording frame rate during Motion recording
- 3. Click to save your settings
- NOTE: If you change your default port number a different port, you still need to enter your port number after the DDNS address.
- 1. In Internet Explorer, enter your DVR’s DDNS address, followed by /webserver
- 2. Enter the DVR’s user name and password and then click OK.
- 3. Click on the ActiveX toolbar, and click Install ActiveXControl.
- 4. At the Security Warning prompt, click Install.
- 5. Click Next to install the Web Server software. Click Close to complete the installation.
- Up arrow
7
Frequently Asked Questions: DH200
+
Series
5. Click Next to install the Web Server software. Click Close to complete the installation.
How do I remove the Video Loss icon that appears on screen?
When the Video Loss icon appears ( ), press the Cancel/ESC button on the remote, or press
the UP arrow on the front panel of the system to remove the Video Loss icon.
Up arrow
Cancel/ESC