Instruction Manual
Table Of Contents
- Basic Setup
- DH230: Front Panel
- DH230: Rear Panel
- DH250: Front panel
- DH250: Rear Panel
- Remote Control
- Using the System
- Getting Started
- Recording
- Playback
- Search
- Setting up Sequencing
- Setting up Motion Recording
- Using the Main Menu
- Backup
- CMS-DH Central Management Software
- System Requirements
- Prerequisites
- Installing CMS-DH
- Starting CMS-DH
- Adding a Virtual DVR
- Creating New Group Folders & Sub folders
- Configuring General System Settings
- Adding Users
- Recording Video to the hard drive
- Playing back recorded video
- Remote Search
- Local Search
- Schedule Recording
- Schedule Backup to Local Hard Drive
- Configure Backup to FTP Server
- Taking Screen Captures
- Viewing File Download Status
- Changing viewing modes
- Sequencing
- E-Map
- Adding Multiple E-Maps
- Viewing DVR Health
- Closing windows
- Locking Windows
- DVR Log
- Upgrading the firmware remotely
- Configuring Post Event Action Tab
- Configuring Alarm Output
- Configuring other Post Action Events
- POS Data Search
- Running CMS-DH on multiple monitors
- iSMS Client (Remote Viewing on the Mac)
- Using the iSMS Client
- Configuring the iSMS Client
- iPhone: Digi iMobile Touch App
- Android: Digi iMobile Touch Lite App
- Installing the BDVRViewer App on your Blackberry
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C:Digimerge Auto Port Forward Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Setting Up Mobile Access
- Appendix F: Connecting PTZ Cameras
- Appendix G: Connecting Additional External Monitors
- Appendix H: Connecting Motion / Alarm Devices
- Appendix I: Full Connectivity Diagram
- Appendix J: Replacing the Hard Drive
- Appendix K: Using Listen-in Audio
- Appendix L: Remote Viewing using Internet Explorer
- Appendix M: DH230/250 Series Touch Screen Monitor Setup
- Troubleshooting
97
CMS-DH Central Management Software
Configuring Post Event Action Tab
The Post Event Action tab allows your system to alert you when an alarm event triggers the DVR.
For example, when the system detects motion from an input device, the computer speakers plays
a sound to alert you. Or, you can have the CMS-DH software alert you with a pop-up window when
motion is detected.
Setting up Post Event Actions on a NO/NC Device
Prerequisites (If setting up NO/NC Devices)
• Connect the input device into the alarm block in the rear panel of the DVR.
•
Ensure you have the correct settings for the device (N/O , N/C), and that you have correctly
configured the settings in the DVR menu.
• Ensure the DVRs are online.
To configure the Post Event Action tab:
1. Expand the menu tree under the desired DVR that you wish to configure.
2. Under Alarm Input, right-click the number block that your device is connected into.
3. Click Po
st Event Action.
4. Configure the following:
• Events: Select Alarm Input ON or Alarm Input OFF
•
Command: Select from Play Sound or None.
Right-click on
the device you
wish to
configure