Instruction Manual

30
Setting up Sequencing
SETTING UP SEQUENCING
Sequencing allows you to view channels in a rotating interval. There are three modes of sequence
setup : sequence mode, shift mode, and event mode.
Sequence mode & Shift mode
Sequence mode allows you to display channels on a regular rotating interval. For example, the
monitor can display channels 1~4, then channels 5~8. Shift sequence mode retains the same split
screen view, but the channels change continuously within each channel cell.
To set up regular sequence mode:
1. Press the MENU
button on the remote or front panel to open the main menu. Press ENTER
• If using a mouse, right-click to ope
n the virtual remote, then click MENU.
2. Click DISPL
AY.
3. Click the SWIT
CH tab.
4. Beside DEVICE, select MAIN t
o configure the main monitor or SPOT to configure the spot
monitor. If you select SPOT, ensure a spot monitor is connected to the SPOT OUT port on the
rear panel.
5. Configure the following:
• D
WELL TIME: Select the dwell time (the time duration before the channel changes).
• MODE: Select SEQUENCE or SHIFT.
• SPLIT MODE (MAIN configuration only): Select the desired split-screen style.
• USE CHANNEL: Select the channels you want to view in sequence view.
6. Press MENU on the r
emote or click ENTER.
7. Exit to the main viewing window. Press and hold the DISPLA
Y button for 2 seconds on the
remote or front panel to begin sequence view. To exit sequence view, press DISPLAY on the
remote or front panel or press the camera number on the remote.
Display
Switch