Instruction manual

31
Web Configuration
You can set the camera’s date and time the following ways:
The camera is configured to use NTP by default, but you
must set the time zone and Daylight Savings Time settings
to ensure accurate time. After a power failure, the camera
is configured to connect to an NTP server and automatically
update the time when power is restored. If using another
method to set the camera clock, time must be manually
updated after a power failure.
• Using an NTP server (recommended)
• Using your computer’s system time
• Manually
To set the camera’s date and time us
ing an NTP server:
1. Click De
vice Configuration>Date & Time.
2. Under Time Zone, sele
ct your time zone.
3. If your region observes daylight savings time, check Adjust clock for
daylight saving changes.
• Under
St
art and
End, select the start and end times for daylight savings.
4. Next to Current PC Time, click Apply.
To sync the camera’s date and time to your computer’s system time:
1. Cl
ick De
vice Configuration>Date & Time.
2. Un-check Enable
NTP and click Apply at the bottom of the screen.
3. Under Time Zone, sele
ct your time zone.
4. If your region observes daylight savings time, check Adjust clock for
daylight saving changes.
• Under
Start and
End, select the start and end times for daylight savings.
5. Click Appl
y next to Current Computer Time. The Current Device Time
updates.
To set the camera’s date and time manually:
1. Click De
vice Configuration>Date & Time.
2. Under Time Zone, sele
ct your time zone.